Ceiling Fan Blue Wire

Install a new blue wireless ceiling fan ...? Help? 3

The cables we use are e, grounding and fan we have e and green. I mean a, and a, and green for Earth ... but where does red come from? DEF is not green !!! This is the key element. We also have 2 bushes ... one for the lamp and one for the fan. Help as soon as possible!

update

There is a two-way SW. For a fan and a lamp. The fan part works, but we don't know how to operate the lamp.

Okay ... we've changed from red to green / ground and the circuit breaker is out of order. We sat down and the two women were working on the fan but there was no light. Then we set to E and the circuit breaker breaks ... Any other options? Coincidentally, this fan is equipped with a remote control.

Ceiling Fan Blue Wire

Disconnect the power supply for IF / Circuit Breaker then check all the cables in the upper ditch.
The fan connection should have an electrical wire (neutral conductor), a green wire (for ground as you found) and 2 more wires from the fan rod / duct, one controls the fan and the other light Controls From your sw you have e (neutral), green or ■■■■ (sun) and red. OK and one e, green or white with green or white (ground), with red (fan or light) for the rest of the fan wires (except the fan or light wire attached to the switch). Red wires and switch pins and neutral, green or bare. They are always connected to used cables (not in electronics such as HVAC controls and devices). When you connect the remote control, the modules leading to the fan connection area are about the same size, green to green, switch to module, then (?) Module in fan cable, red to red (?) Change from module to red (?) Module to fan light cable. Reconnect the power and check the operation. Check the outline in the manual or module to confirm the input / output wiring for lamps and fans. To like!
I'm a little stupid. If there is light in the fan, the blue wire leading to the light is missing. Wires for fans / lights should be used for proper wiring. Fan / light cable uses a cable. Use blue light / fan wire on the red wire. Green ground wire
The reason I noticed is that you did not say that the fan was a simple fan or was purchased as a fan or a combination of lights. When turning on the fan, it is necessary to transfer one additional cable from the device to the ceiling box along with the other cable. You may think that you need to attach the lamp to the fan. Fans and lights need your right foot.
People use a four-wire system when people operate a device in more than one location or provide uninterrupted power to another device or outlet. Red and he always t. If the string is the only string holder, do not use it, leave the string holder alone. Sometimes people use four wires because they have them. If you also want to keep the fan separate from the light, you can run the power supply through a four-wire cable separate from the switch, with one side running the fan and the other running the lamp.
It looks like the cable you are using is a 3 way cable. It has 2 conductors (and red) along with ground and e / neutral. Is there a 3 way switch for this fan?
Go with it to turn on the fan or light.
Try connecting the blue wires.
Not just blue with snow