Pool Table Slate Replacement

Where can I buy a replacement board for an L-shaped table? 3

I think I have a problem with my 8 foot gondi table slate, so I think it may need to be replaced. The slate itself does not have S, but I cannot make a three-part slate scale cut (with middle and edges) regardless of the surface. I used gate level com and then a mast level (Starrett 98) to try to get the level within 23 per thousandth of an inch. I'm not sure if I'm going to buy a new whiteboard or how much it will cost.

What could be the reason for this or any suggestion about boards being bent etc.?

Thank you very much

Ignore Mark first (as usual), he's a kid who doesn't know what he's talking about and just wants to spam his parents' website (Ozonelliards).

Inevitably, some people will come and say that the slate cannot be fixed. You are wrong The board may be bad but it is very unlikely. If there is a defect in the table that prevents it from leveling, it is most likely due to a problem with the support structure on which the boards are placed. For your information, slate chains have the same causes as wood chains: excessive humidity and / or drastic changes in temperature. Slate is much less insecure than wood, so it is much less, but it is unsafe and can deteriorate. You should not get angry or try to do anything to avoid it. The problem when your table is in the environment (for example, very wet bats or garage or guard) are crooked reference points.

The best option is to contact a local desktop dealer who will install and explain the problem and see what it says from the inside. Be careful, they may only offer to level the table for you, but they do not really have the experience to diagnose or fix the actual table problems. This is probably the best because the cost of repairs, even for those who know the table can cost more. Of course, you can have everything you need to be a supporter to level your table.

Replacing the whiteboard is usually not an option. The slate itself can be quite expensive (in the range of $ 500 to $ 1000) and that means you can get one. Most of the time, if it were a whiteboard, you would go to the dealer who sold your desk to ask the manufacturer for more. Your problem is that Gandy is no longer on the market (actually, they make some decent boards unlike Mark says), so you won't find anyone who sells the right slate for your table game or Sells

So call the locals and see what they can do, but there's a good type.