What are the regulations for pool fencing in Victoria?
If a Victorian residential pool or spa has a depth of 30cm or more (300mm), it is required to be surrounded by safety barrier. Placing a cover or lid over a swimming pool or spa does not comply and is not acceptable. A safety barrier is required. Safety barriers must be a minimum of 1.2 metres high.
Can you build your own pool fence in Victoria?
If you already have a pool or spa If you are having any work done on an existing safety barrier, a permit may need to be issued to alter the barrier. Work to alter an existing barrier will need to comply with the current Regulations. Check with your local council or building surveyor for advice.
Are pool fences compulsory in Australia?
By law your pool or spa must be registered with council relevant to your area. All pools must be fully enclosed by a barrier that is at least 1200mm in height, barriers can include fencing or walls. The bottom of the pool fence and gate must be no more than 100mm off the ground.
What is the fine for not having a pool fence in Victoria?
In addition, owners must have a registered building surveyor or inspector certify the continuing compliance of their safety barrier every four years. Owners who fail to register their pool or spa with their council by 1 November 2020 may face an on-the-spot fine of $330.
Can a boundary fence be a pool fence in Victoria?
Can a boundary fence be a pool fence? If a boundary fence is used as a pool barrier, then this must be at least 1800mm in height. If the fence has vertical members, then these cannot be more than 100mm apart, horizontal members no less than 900 mm apart.
What size fence is required around a pool?
Fence height and clearance requirements: Installed pool fences should be at least 48-inches high from finished ground level, as measured along the outside of the fence and should have no more than a two-inch gap from the bottom of the fence to the ground.
Can you use a boundary fence as a pool fence Victoria?
Pool fences need to be at least 1200mm (1.2m) high or if the boundary fence is used, the boundary fencing section must be at least 1800mm (1.8m) high. Make sure that there are no footholds or indentations greater than 10mm (1cm) on your fencing that children can use to climb over the fence into the pool area.
Is it illegal to not have a fence around your pool?
Swimming pools that are in ground, completely or partially, must be enclosed by a fence. Portable pools are usually not legally required to have a fence. However, if unfenced, between uses they should be either covered or emptied and stored.
How far must a pool be from a fence?
According to the Swimming Pool Regulation, your pool must be surrounded by a sturdy and compliant pool barrier. As a pool owner, you must understand that your pool fence should be at least 1200mm from ground level. Additionally, there should be no more than 100mm gap between the fence bottom and the ground.
What kind of fence is required around a pool?
According to the safety guidelines from the U.S. Consumer Product Safety Commission, pool barriers and fences should be a minimum of 4 feet tall and should surround all sides of a swimming pool. The house can act as one ‘side’ of the pool barrier, with the remaining sides surrounded by a privacy fence or other barrier.
Do I need a fence around my pool?
Swimming pools that are in ground, completely or partially, must be enclosed by a fence. Above ground pool installations may need fencing, depending on water depth. Portable pools are usually not legally required to have a fence. However, if unfenced, between uses they should be either covered or emptied and stored.
How deep can a pool be without a fence?
How Deep Can A Pool Be Without A Fence? In most areas, a pool can be less than 18″ and not need a fence or barrier surrounding it.
Do you need a fence around a swimming pool in Victoria?
All swimming pools and spas on residential properties in Victoria with a depth greater than 30cm (300mm) are required to be surrounded by a safety barrier (e.g. a pool fence).
What is the standard height of a pool fence in Australia?
Pool Fence – Height Australian Standard AS 1926.1 – 2012 stipulates that a pool fence shall be not less than 1.2m high all the way around. Note: If the pool barrier is not 1.2m high all the way around or only in some sections then the home owner should seek immediate advice from a Licensed Builder, Pool Technician or Fencing Contractor.
Do you need a building permit for a pool in Victoria?
Victorian property owners with a pool or spa with no barrier or sub-standard barriers are obligated to meet the standards of the regulations at all times. It should be noted that for most city councils a building permit is also required for new pool fencing.
Are swimming pools and spas regulated in Victoria?
We encourage the active supervision of young children in and around swimming pools and spas at all times. In Victoria, the construction and installation of swimming pools, spas and safety barriers and barrier maintenance are all subject to the requirements of the Building Regulations 2018 (the Regulations).
